Here is a generic solution from quickload. A 105 gr with a H4350 44.9 and 45.8 are close to velocity nodes. The OBT nodes are 1.191 (#4 node) and 1.162 (#3.5 node). This is just to give you an idea, I would need more information to fine tune it. Please don't take this as load data, and proceed at your own risk. I also attached a list of powders from QL that are listed by velocity with a 105% or less fill ratio and a 60000 PSI pressure ceiling. Good luck, hope it helps. PM if you have any questions. Rjh.
-10.0 87 40.41 2858 1904 44511 10013 97.3 1.366
-09.0 88 40.86 2887 1943 45847 10116 97.6 1.347
-08.0 89 41.31 2916 1982 47221 10217 97.9 1.328
-07.0 90 41.76 2944 2021 48634 10314 98.2 1.310
-06.0 91 42.21 2973 2061 50087 10409 98.4 1.292
-05.0 92 42.66 3002 2101 51582 10500 98.7 1.275
-04.0 93 43.10 3030 2141 53120 10587 98.9 1.257
-03.0 93 43.55 3059 2182 54701 10671 99.1 1.241
-02.0 94 44.00 3087 2222 56329 10752 99.3 1.224
-01.0 95 44.45 3116 2263 58003 10829 99.4 1.208
+00.0 96 44.90 3144 2304 59726 10902 99.6 1.192
+01.0 97 45.35 3172 2346 61500 10971 99.7 1.176
+02.0 98 45.80 3200 2387 63325 11037 99.8 1.161
+03.0 99 46.25 3228 2429 65204 11098 99.9 1.145
+04.0 100 46.70 3256 2471 67139 11156 99.9 1.131
+05.0 101 47.15 3283 2514 69131 11210 100.0 1.116