any tips for setting up a rcbs quick change powder thrower

texasgunclass

New member
I have a rcbs quick change powder thrower coming and I was wondering if there is anything I need to know to make the setup go smoothly, I have a digital dispenser now but it takes forever to load and I thought this might be quicker.
 
I have a uniflow which looks relatively similar to the quick change. As I'm sure you're already tracking, powder selection is key. Throwing 3031 and larger sounds like crunching sand, no bueno. Also, do run the pound of powder threw it before using it to load. It does help coat the insides. Also, YMMV but I found that a stand Is a must. Much handier than press mounting.
 
To add to that, whenever I go to throw and it gets hung up and I bring the lever down and up again, it always adds a bit extra to the weight. I will usually just dump that throw back into the hopper.
 


Write your reply...
Back
Top