CoyoteKillerCole
New member
Anyone have any experience with this stock and know if it will fit a savage 10 predator 22-250 or will I need to have some trimming done on it?
Boyd’s featherweight Thumbhole stock
- Thread starter CoyoteKillerCole
- Start date
I've had/have several Boyd's stocks including the TH models. Most have fit very good. I won't say that sometimes you won't need to knock a corner down or smooth out a proud area but usually they are drop in. If you order the correct stock for your model, you shouldn't have any problems. Any fitting I had to do usually only took a few minutes. Never anything major.
Bob_Atl
Well-known member
Statistics of two, both from Boyds, one for Ruger American Predator 6.5cm,
other for Ruger American Rimfire 22 mag (new thumbhole style)
and both required a couple hours of dremel work to get mag release acceptable.
Both would not allow mags to be fully inserted without the mods.
If I didn't mind a sticky mag, could have been done in 1/2 hour each.
Went with B&C for last RAP refit - it was flawless, worth the extra $$.
other for Ruger American Rimfire 22 mag (new thumbhole style)
and both required a couple hours of dremel work to get mag release acceptable.
Both would not allow mags to be fully inserted without the mods.
If I didn't mind a sticky mag, could have been done in 1/2 hour each.
Went with B&C for last RAP refit - it was flawless, worth the extra $$.