Just seen the picture of your gear in another post,cool man! I hope you enjoy it as much as I have.
Thought I might clarify a little bit on a couple things, the mistake I made about the dies; I was used to setting up bullet seating dies without a built in crimp, then went to set up a .204 Ruger die which has a built in crimp, and ended up buckling/destroying 2 rnds, before I said hmm what the hecks going on here (sensored version).
By sneaking up on it I mean what you will do after screwing in your die per the instructions (touching the shell holder, then in or out x amount of turns), then at this point you will just seat the bullet a little bit at a time, making small adjustments untill COAL is achieved.
Clear as mud??
