Help finding hard to find Winchester parts

Gomer_Pyle

New member
Winchester model 94 (pre-1964)
Anybody know where I can help a friend come up with some screws for this rifle?
They go in the holes where the weaver side mount goes. He took the side mount off and needs the original screws that "fill" the holes where the weaver mounted.
He found a kit where he can buy all 18 screws for the gun, but was hoping to find just the 3 screws that he needs rather than buy the whole kit.

Thanks
 
Try Numrich Gun Parts.

Also if you know the thread count and size you can buy them from numerous sources (Brownells, Midway etc.) look in places in the catalog that are for other than the specific gun as it is possible that the screws are common screws used to hold scope bases and the like on.

I know these facts because I am the man that likes to drop small screws in dark rooms never to be found and have had to replace more than a couple myself. Actually last time it was a drift pin for an AR-15 extractor, on my duty rifle no less. Had to pay extra to have that one overnighted after I stole one from my Bushmaster. /ubbthreads/images/graemlins/smiliesmack.gif /ubbthreads/images/graemlins/angry-smiley-055.gif

I will do some searching tomorrow and see if I can send you a link.
 
I don't believe that pre-64 M94 rifles were tapped for side mounts, at the factory. Previous owner probably had this done by a gunsmith. Standard Weaver mount screws should fit. Try Brownell's.
 
Quote:
I don't believe that pre-64 M94 rifles were tapped for side mounts, at the factory. Previous owner probably had this done by a gunsmith. Standard Weaver mount screws should fit. Try Brownell's.



This is most likely the case. Do you see a bevel or countersink?
 


Write your reply...
Back
Top