Hornady Lock-N-Load Die bushings question ....

Hidalgo

Hidalgo

Well-known member
Is anyone using the Hornady Lock-N-Load die bushings shown below? If you are, how are you storing your dies when not is use? The dies won't fit back in the original storage boxes with the bushings installed. I love this system but die storage out of the dust, etc is concerning.

https://www.midwayusa.com/product/1165277407
 
Take a 2x4 and drill holes for the bushing to fit in and you can have them on the bench ready to go. You can take a marker and label the holes for easier ID of the die. I dill four holes and store my Lee four hole turrets like that.
 
I use them on all my dies. RCBS and Hornady Custom, they fit in the box just fine. They might not rest perfectly in plastic grooves but to stack on a shelf there's no issue.

You could always cut the molding out and put some foam in the box.
 

Actually, I just found these on Etsy (not a big fan of that site, but I have used it before) and they look like a great solution. The holes are the correct diameter for the bushings. Thanks for everyone's suggestions also !

il_1588xN.5303902716_n873 by John Doe, on Flickr
 
i have a similar one of these on my bench, with labels on each drawer for the caliber. then all my bits/bobs for said caliber go in there. dies. shell holder. shell plate, etc.

61vFYN1QysL._AC_SL1200_.jpg
 
Back
Top