Reply to thread

Message

My Savages have pillars but the action touches nothing but Devcon. When bedding I use 1/4x28 bolts with the heads cut off and wrapped with tape to center the bolts in the pillars when screwed into the action. I wrap masking tape 2 times around the barrel about 4" from end of stock to center the barrel in the stock and to make sure barrel is free floated. When bedding I hand squeeze the action to where the ejection port is dead even with the stock and wrap a paper towel around the action and stock then use electrical tape pulled tight and wrap around the action and stock to hold it in place while curing. I use Kiwi neutral shoe polish buffed for a release agent. Works for me.

[QUOTE="Tnslim, post: 2968399, member: 25704"] My Savages have pillars but the action touches nothing but Devcon. When bedding I use 1/4x28 bolts with the heads cut off and wrapped with tape to center the bolts in the pillars when screwed into the action. I wrap masking tape 2 times around the barrel about 4" from end of stock to center the barrel in the stock and to make sure barrel is free floated. When bedding I hand squeeze the action to where the ejection port is dead even with the stock and wrap a paper towel around the action and stock then use electrical tape pulled tight and wrap around the action and stock to hold it in place while curing. I use Kiwi neutral shoe polish buffed for a release agent. Works for me. [/QUOTE]

Verification