orkan
Active member
As an avid handloader, I am always searching for ways to streamline my processes and equipment in my reloading room. Every few years I will go through a completely new evolution and redesign of my benches. It seems that every time I rebuild, I come up with a better way to do things almost immediately after. Press mounting has always been an area I've not been completely happy with. There are a number of reasons why this has always been difficult. Each press or tool I need to affix to my reloading bench seems to have a completely different bolt pattern from one to the next. The hardware and bolt pattern needed for my Forster Co-Ax is decidedly different from that needed to mount an RCBS Rock Chucker. This resulted in new holes bored through the bench every time something new was purchased. After a while, the bench started to look like swiss cheese. I'm happy to say today all of that unpleasantness is behind me, and I owe it all to Inline Fabrication and their Ultramount QD press mounting solutions! Read on to learn about why these mounts can save you substantial time and effort in your own reloading rooms.
READ FULL REVIEW
If you purchase your own Inline Fab Ultramount setup, use coupon code PRIMALRIGHTS for special discounts.