Originally Posted By: pahntr760There is no need for ft/lbs wrenches if you can do math. 30-80 ft/lbs is 360-960 in/lbs. Also, torque wrenches are not overly expensive. I've used some from Harbor Freight and used the same testing/calibration procedures that we use in the AF for use on aircraft. They hold true and dont break the bank.
A good AR wrench is a bit spendy, but worth it. The cheaper one will either break during usage or wreck the component you are trying to tighten/loosen. I prefer a traditional open end wrench for muzzle devices. But that is just a preference thing.
The 2X4 with holes drilled for the mounting studs sounds like a great idea. More surface contact is going to be more stable and secure. And I see a lower likelyhood of damage with this method.
So...no...and action block isnt needed.
What inch lbs torque wrench are you using? Mine only goes up to 200 inch lbs.
