Originally Posted By: littledawgEver figure this prob out? I added some sounds and mine it doing the same thing. Never had this happen before.
So after fighting this problem all morning I finally got the sounds to go into the right categories. They were numbered correctly if I looked at the sound list on the remote. If I looked at the categories on the FP utility program is looked just like I wanted it to look, but it was all messed up in the categories after updating the remote despite being right on the sound list. What I found is the number assigned to each sound in the categories was out of sequential order, meaning I had say 125 listed before 022. In fact, I had them listed as to how often I like to use them and didn't pay attention to the number. You can skip numbers in the category like going from 003 to 013, BUT 003 must be listed before 013. Basically it must go from low to high by the three digit sound number. I did this and it loaded just as I had it in the categories. I hope this makes sense and helps.