Originally Posted By: VarminterrorOriginally Posted By: 204 ARGood detail there. I too change the trigger springs on the RRA, leave the hammer spring alone, and change the disconnector spring by punching out the pin that holds it in. That allows you to change the second stage pull. I can get first and second stage pulls in the 1.25 lb stage, or under, that way.
What replacement spring do you use? I've never pushed one out on an RRA trigger, but I've been tempted to do so on many occasions. BUT... I want to have the replacement spring in hand before I do so.
I use the JP spring, IIRC it comes with the same kit as the trigger spring. Trim 1/2 a coil at a time, test pull weight, repeat as necessary till the pull is to your liking. To hold the little pin back in, I degrease and use a dab of JB weld over the head of the pin. I've done this on, IDK, 7 or 8 at least over the last 4 or 5 years without problems.