Ruger American and magpul hunter stock

Clayton86

New member
I recently picked up a ruger American predator in 243 and ordered the magpul stock with it. Fits great and like the way it shoulders and feels but I can’t take the bolt out to clean the it without taking the action from the stock. Is there a trick or mod I can do to get the bolt in and out without disassembly or taking the dremel to the stock where it hits.
 
Clayton86:

Go to Ruger's site and call up the owners manual for the Ruger American Rifle. At the very end there are instructions on how to remove/install the bolt with the Magpul stock on it.

Take care,
Bob
 
Last edited:
There's one screw that hold the butt assembly on. At least on the Remington model. Take the screw out and slide the butt assembly out then lift up on the cheek piece. Comes right off. Should be plenty of room to remove the bolt then.
 
Awesome thanks, and thanks I completely forgot that was my signature on here I did 7.5 years in and I’ve been out about 6 years now and miss it.
 


Write your reply...
Back
Top