Reply to thread

Message

I have a savage 16fss in 308. what I did was to cut a groove in the bottom of the fore end where all the honeycomb is. I used a router to cut a 3/8" groove and then took an aluminum 12 ga cleaning rod and cut a piece to lay in the groove. I then filled the fore end with re inforced acra glass bedding compound. after that I re-inletted the barrel channel and glass bedded the action. then I filled the buttstock with foam. nice and solid now.

[QUOTE="tgrif, post: 1352765, member: 20186"] I have a savage 16fss in 308. what I did was to cut a groove in the bottom of the fore end where all the honeycomb is. I used a router to cut a 3/8" groove and then took an aluminum 12 ga cleaning rod and cut a piece to lay in the groove. I then filled the fore end with re inforced acra glass bedding compound. after that I re-inletted the barrel channel and glass bedded the action. then I filled the buttstock with foam. nice and solid now. [/QUOTE]

Verification