Shell holders for a Lee breechlock challenger kit

R

redfoxtrapper

New member
I'm new to reloading. I bought a Lee Breechlock Challenger kit. It is supposed to have everything needed besides the dies to start loading. My kit has the shell holders in the red box for the autoprime but not the holders in the green box that are installed in the press to hold the case while it is being resized. Is it supposed to contain these holders? If not, how can you resize the case without it sticking? I went to the Lee site and could not find a way to contact them. Thanks.
 
You'll get your shellholders with each set of dies you buy,like DDJ said. Unless you buy the RGB Dies, they don't come with those. You can also buy the group of shellholders for the press the same as the ones for the Autoprime.
For the Resizing you'll need case lube, all different kinds are available, any kind will do the job, but you'll likely find a favorite type, as most of us do.
Read up on the basics before getting started. Plenty of good info on here, but a good book still has it's place and always will.
 
For lube, I use Imperial sizing wax. I know others like it as well, and I have not stuck a case with it yet. I can't say the same for One Shot. I have the same set as you, and it has served me well. Good Luck.

kevlars
 


Write your reply...
Back
Top