Reply to thread

Load #3


10 Gauge


Hull: Federal 3.5”

Primer : CCI-209

Powder: 36.8grs Blue Dot

Wad Column: BPD-10 (molly or HBN coated with three petals split 2/3 the length of the wad) – (1) 1/4” and (1) 1/8” felt or wool wads in the bottom of the cup

Buffer:  Ground polyethylene (Ballistic products SD-C works well - add about 2 grams of molybdenum disulfide to 1 pound of buffer) – add buffer with gentle tapping till all interstitial sites are filled and the buffer is level with the top of the shot column.

Shot:  45 pellets lead 4-buck

Crimp:  Roll crimp with Ballistic products 12ga. frangible plastic over shot disk and seal the edges with a soft silicone (a small syringe works well for this).

Velocity: 1210fps

Pressure: 10.8KPSI

 

Notes:  This load work well in auto loaders.  An average patterning load that should be kept in the 40-85 degree F range.


Back
Top