New posts

Reply to thread

Message

Load #6

10 Gauge

Hull: Federal 3.5”
Primer : CCI-209M
Powder: 44grs SR-4756
Wad Column: Ballistic Products MM1050 (molly or HBN coated pre-split) – (2) 1/4” felt or wool wads in the bottom of the cup
Buffer: Ground polyethylene (Ballistic products SD-C works well - add about 2 grams of molybdenum disulfide to 1 pound of buffer) – add buffer with gentle tapping till all interstitial sites are filled and the buffer is level with the top of the shot column.
Shot: 58 pellets lead T-buck
Crimp: Fold crimp with a Precision Reloading tyvek over shot wad on top of shot column. Seal the crimp with soft silicone
Velocity: 1300fps
Pressure: 10.5KPSI

Notes: This load can pattern very tightly in some guns, in others it tends to cluster several pellets and then leave big holes. This load has functioned very well for me down to about 15 degrees F.

<blockquote data-quote="pcammo" data-source="post: 2202506" data-attributes="member: 9853">Load #610 GaugeHull: Federal 3.5”Primer : CCI-209MPowder: 44grs SR-4756Wad Column: Ballistic Products MM1050 (molly or HBN coated pre-split) – (2) 1/4”&nbsp; felt or wool wads in the bottom of the cupBuffer:&nbsp; Ground polyethylene (Ballistic products SD-C works well - add about 2 grams of molybdenum disulfide to 1 pound of buffer) – add buffer with gentle tapping till all interstitial sites are filled and the buffer is level with the top of the shot column. Shot:&nbsp; 58 pellets lead T-buckCrimp:&nbsp; Fold crimp with a Precision Reloading tyvek over shot wad on top of shot column.&nbsp; Seal the crimp with soft siliconeVelocity: 1300fpsPressure: 10.5KPSI&nbsp; Notes:&nbsp; This load can pattern very tightly in some guns, in others it tends to cluster several pellets and then leave big holes.&nbsp; This load has functioned very well for me down to about 15 degrees F.</blockquote>

[QUOTE="pcammo, post: 2202506, member: 9853"] Load #6 10 Gauge Hull: Federal 3.5” Primer : CCI-209M Powder: 44grs SR-4756 Wad Column: Ballistic Products MM1050 (molly or HBN coated pre-split) – (2) 1/4” felt or wool wads in the bottom of the cup Buffer: Ground polyethylene (Ballistic products SD-C works well - add about 2 grams of molybdenum disulfide to 1 pound of buffer) – add buffer with gentle tapping till all interstitial sites are filled and the buffer is level with the top of the shot column. Shot: 58 pellets lead T-buck Crimp: Fold crimp with a Precision Reloading tyvek over shot wad on top of shot column. Seal the crimp with soft silicone Velocity: 1300fps Pressure: 10.5KPSI Notes: This load can pattern very tightly in some guns, in others it tends to cluster several pellets and then leave big holes. This load has functioned very well for me down to about 15 degrees F. [/QUOTE]

Verification