New posts

Reply to thread

Message

Load #10

12 Gauge

Hull: Federal 3” Gold Metal
Primer : WW-209
Powder: 29grs SR-4756
Wad Column: Precision Reloading TUFW123 (molly or HBN coated with pre-split) – (1) 1/8” felt or wool wads in the bottom of the cup
Buffer: Ground polyethylene (Ballistic products SD-C works well - add about 2 grams of molybdenum disulfide to 1 pound of buffer) – add buffer with gentle tapping till all interstitial sites are filled and the buffer is level with the top of the shot column (about 20 grains).
Shot: 32 pellets lead 4-buck
Crimp: Fold crimp with a Precision Reloading tyvek over shot wad on top of shot column. Seal the crimp with soft silicone
Velocity: 1225fps
Pressure: 11.2KPSI

Notes: This has long been a favorite 12 gauge load for my BP-12. It patterns well and performs well in colder temperatures. It also burns fairly clean in all but the largest over bore shotguns.

<blockquote data-quote="pcammo" data-source="post: 2202547" data-attributes="member: 9853">Load #1012 GaugeHull: Federal 3” Gold MetalPrimer : WW-209Powder: 29grs SR-4756Wad Column: Precision Reloading TUFW123 (molly or HBN coated with pre-split) – (1) 1/8” felt or wool wads in the bottom of the cupBuffer:&nbsp; Ground polyethylene (Ballistic products SD-C works well - add about 2 grams of molybdenum disulfide to 1 pound of buffer) – add buffer with gentle tapping till all interstitial sites are filled and the buffer is level with the top of the shot column (about 20 grains). Shot:&nbsp; 32 pellets lead 4-buckCrimp:&nbsp; Fold crimp with a Precision Reloading tyvek over shot wad on top of shot column.&nbsp; Seal the crimp with soft siliconeVelocity: 1225fpsPressure: 11.2KPSI&nbsp; Notes:&nbsp; This has long been a favorite 12 gauge load for my BP-12.&nbsp; It patterns well and performs well in colder temperatures.&nbsp; It also burns fairly clean in all but the largest over bore shotguns.</blockquote>

[QUOTE="pcammo, post: 2202547, member: 9853"] Load #10 12 Gauge Hull: Federal 3” Gold Metal Primer : WW-209 Powder: 29grs SR-4756 Wad Column: Precision Reloading TUFW123 (molly or HBN coated with pre-split) – (1) 1/8” felt or wool wads in the bottom of the cup Buffer: Ground polyethylene (Ballistic products SD-C works well - add about 2 grams of molybdenum disulfide to 1 pound of buffer) – add buffer with gentle tapping till all interstitial sites are filled and the buffer is level with the top of the shot column (about 20 grains). Shot: 32 pellets lead 4-buck Crimp: Fold crimp with a Precision Reloading tyvek over shot wad on top of shot column. Seal the crimp with soft silicone Velocity: 1225fps Pressure: 11.2KPSI Notes: This has long been a favorite 12 gauge load for my BP-12. It patterns well and performs well in colder temperatures. It also burns fairly clean in all but the largest over bore shotguns. [/QUOTE]

Verification