Reply to thread

Message

Like the other guys have said get a MEC. I have a couple 600’s one is set up for each of my SXS in 12, 16, 20 and 28 ga with an extra set of .410 load set. If you watch eBay you can find pretty good deals on them. They last forever. My 12 ga press is the same on I remember helping my dad and grandpa load up shells before they went out pheasant hunting. And the same one I grew up reloading my shells the night before a hunt. If you get a mec do get the universal charge bar. Kind of a pain to figure out but once you do I have found them to be very consistent dropping powder and easier than buying a bunch of charge bars and bushings. You can also fine tune it easier-better than drilling out bushings.

[QUOTE="Flybum, post: 3157366, member: 51155"] Like the other guys have said get a MEC. I have a couple 600’s one is set up for each of my SXS in 12, 16, 20 and 28 ga with an extra set of .410 load set. If you watch eBay you can find pretty good deals on them. They last forever. My 12 ga press is the same on I remember helping my dad and grandpa load up shells before they went out pheasant hunting. And the same one I grew up reloading my shells the night before a hunt. If you get a mec do get the universal charge bar. Kind of a pain to figure out but once you do I have found them to be very consistent dropping powder and easier than buying a bunch of charge bars and bushings. You can also fine tune it easier-better than drilling out bushings. [/QUOTE]

Verification