Slings, and attachments

[Longnkrnch]

I have a RRA ATH with 6 position stock. I have tried a single point sling and just don't like it. Does anyone know where I could get a standard sling stud to replace the OEM rear sling mount so I can just clip the sling in like a standard rifle?? I was able to get one for my .450 Bushmaster with A-2 stock, but it just doesn't fit right on the 6 position stock. If I have to, I think I can make one, but would rather have a "store bought"

 

[Billsauk]

http://www.knsprecisioninc.com/gun-parts-and-accessories/kns-products/angled-rear-sling-mount.html

I put this on my 6 pos stock and like it a lot. I did have to grind out a small amount on the stock to slide in into place. Is this what your thinking of?

 

[Stirling XD]

Originally Posted By: Billsaukhttp://www.knsprecisioninc.com/gun-parts-and-accessories/kns-products/angled-rear-sling-mount.html

I put this on my 6 pos stock and like it a lot. I did have to grind out a small amount on the stock to slide in into place. Is this what your thinking of?

That's what I did as well. It works great, but it was a tight fit.

 

[Outwest1]

midway usa has the exact replacement sling stud you need.

 

[Longnkrnch]

It looks very similar to what I installed on my A2 stock, which is a little short to work on my 6 pos straight up. The one I have would work if mounted to the side. This one might be a little longer. I might just try it. If a little short, I think a little weld and grind job would make it work.
Thanks

 

[willy1947]

I have tried all kind of slings and studs.
I have changed most of my AR's to push buttons.