Reply to thread

If I remember right, the one under the safety needs to be let out, then let the tension screw out more, mess with it til you get close to desired pull....Adjusting the tension between the 2 screws.


You'll be able to tell when the safety gets "iffy"...


Then go back & adjust it up a tad, until the safety works every time, no exception.


Note, don't get the safety screw too tight, or it will render the safety switch unmovable.


Disclaimer.....Use this information on your own hook.

(It's kinda hard to get gunsmithing advice online because of the liability involved.)


Back
Top