Reply to thread

Message

I just installed the CWS in my AR it says in their instructions that for adequate overrun there should be approximately 1/16 of an inch when fully retracted between the bolt face and the bolt stop. If the gap is less the bolt may not have enough time to fully extend prior to the bolt contacting it on the forward return of the carrier. Well mine was less so I sanded it down and now it is alot more than a 1/16 of a inch. Do you guys think it will matter that it is more than the 1/16? Is it better to have more?

[QUOTE="BOBTAILS, post: 715211, member: 11244"] I just installed the CWS in my AR it says in their instructions that for adequate overrun there should be approximately 1/16 of an inch when fully retracted between the bolt face and the bolt stop. If the gap is less the bolt may not have enough time to fully extend prior to the bolt contacting it on the forward return of the carrier. Well mine was less so I sanded it down and now it is alot more than a 1/16 of a inch. Do you guys think it will matter that it is more than the 1/16? Is it better to have more? [/QUOTE]

Verification