TC Venture Predator suppressor

you would have to measure the end of the barrel to see if there is enough steel there to allow for a .5"x28 thread.

Is the end of the barrel thicker than half inch? You are going to need to take it to good gunsmith that does this and ask them if there is enough meat there to be able to thread it, and if they would.
 
Originally Posted By: coolbrzeCan the end of the barrel be threaded since it's a relatively thin barrel?

yes it can be threaded 1/2x28. gunsmith threaded mine and it turned out real nice with a good shoulder.
 
Originally Posted By: SlickerThanSnotOriginally Posted By: coolbrzeCan the end of the barrel be threaded since it's a relatively thin barrel?

yes it can be threaded 1/2x28. gunsmith threaded mine and it turned out real nice with a good shoulder.
Quick question STS, did you eave it 22" ??
 
Originally Posted By: Bob_AtlOriginally Posted By: SlickerThanSnotOriginally Posted By: coolbrzeCan the end of the barrel be threaded since it's a relatively thin barrel?

yes it can be threaded 1/2x28. gunsmith threaded mine and it turned out real nice with a good shoulder.
Quick question STS, did you eave it 22" ??

yes i did.
 
Originally Posted By: coolbrzeThx! What caliber & suppressor do you run & do you like it?

i use it on 204, 223 and 17 hornet.

i went the form 1 route and built a 7 inch suppressor. titanium body and stainless steel internals. i have about $155.00 in it for materials. very, very happy with it. not much louder than a 22lr.
 
Originally Posted By: SlickerThanSnotOriginally Posted By: coolbrzeThx! What caliber & suppressor do you run & do you like it?

i use it on 204, 223 and 17 hornet.

i went the form 1 route and built a 7 inch suppressor. titanium body and stainless steel internals. i have about $155.00 in it for materials. very, very happy with it. not much louder than a 22lr.

did you make the suppressor yourself? where can I get that same suppressor if you bought it.
 


Write your reply...
Back
Top