BleedsBlue
New member
Greg,
I am glad to see that you are getting similar results as I. yet I have had good results with the 53 varmegeddon using a 12 twist loaded to 2.30" OAL in a stainless mag. I used 33.4gn of CFE223 at this length reaching 3789 fps with good groups.
its nice to see that redding has made a 22nosler body die. (should make forming easier)
to form my nosgar brass I used 2 FL dies, one with the decapping pin removed then ran them thru a die with a decapping pin.
the initial forming requires partial short strokes to prevent dents on the shoulders.
the water capacity was significantly lower than the nosler brass
I am glad to see that you are getting similar results as I. yet I have had good results with the 53 varmegeddon using a 12 twist loaded to 2.30" OAL in a stainless mag. I used 33.4gn of CFE223 at this length reaching 3789 fps with good groups.
its nice to see that redding has made a 22nosler body die. (should make forming easier)
to form my nosgar brass I used 2 FL dies, one with the decapping pin removed then ran them thru a die with a decapping pin.
the initial forming requires partial short strokes to prevent dents on the shoulders.
the water capacity was significantly lower than the nosler brass