Ok first and foremost this is my first post, but I have read and learned a lot from you all so thank you very much! I have the bmag heavy fluted barreled .17 wsm and just recieved my boydes thumbhole and put it on. I didn't care for the scope combo but that's all they've had for the last six months. I really didn't want the stainless barrel for hunting. Anyways after a lot of research I switched the stock tonight. About two hours later it was finally right! The issue i'v been reading about the most is with the safety not properly functioning. After installing and (crossing my fingers) went to use the safety and it didn't slide. What I ended up doing is simply using two pieces of cardboard that I cut to fit the slot and put holes for the screws to do though. I also had to shim the barrel and file out a bit from the stock because the barrel was rubbing on the left side of the barrel channel, even though I ordered the stock with the bull barrel channel. I will post pictures to hopefully help someone as you all have done for me in the past. Thanks again matt.