Brass catcher for bolt actions?

[pd_buster]

My new Tikka's action is so smooth, it's hard not to let the brass go flying a long ways. I am going to reload them, so I want to save them. Is there any brass catchers that will fit my Tikka T3 Lite? It has a clip that loads from the bottom. Thanks, PD!

 

[Jack Roberts]

Not sure what type ejector the Tikka has but if it is like the 700 you just need to cut down the spring on the ejector. The stock 700 will fling brass 8 feet but once the spring is cut down will dump it within 1 foot of the rifle.

Jack

 

[CatShooter]

I have done the same as Jack on all my Rem 700 and Winchester M70s...
I have found that if you cut the spring to 1.00", the cases will make a neat little pile right next to the rifle - I put a cap next to the rifle, and then pick up all the brass in one swell foop when I'm done.