Burris P.E.P.R. QD not tight. Is this normal?

Dog_Thumper

New member
I just bought a Burris P.E.P.R. QD Scope mount. I am primaritly using it on my hunting rifle, so I know, looking back that I really don't need the QD mount. I probably should have bought the other one, but I got a good deal on it, and had heard good reviews on it.

My question is, I mounted it to my AR, and it isn't tight. It has just a little (very little) but still a little give up and down. From the few target shots I have shot, it is still an acceptable tight group, but I am curious if this is normal?

Any suggestions would be great, and yes, Im assuming I should just buy the non-QD and call it a day, but didn't know if this is what I should expect from the mount I have.
Thanks,
Tyler
 
The cams are adjustable for tension. Open the lever, push it towards the opposite side, tighten the wheel/nut thingy, check tension. There should be no movement.
 
Originally Posted By: pahntr760The cams are adjustable for tension. Open the lever, push it towards the opposite side, tighten the wheel/nut thingy, check tension. There should be no movement.

Im not sure why I didnt think to ask if this was possible...Thank you!
 
^^ yup, the other side has the nut w/slots that you can feel, turn 1-2 notch at a time as it don't take to much to get it real tight.
 


Write your reply...
Back
Top