Cheek Weld Pads

LUCKYDOG

LUCKYDOG

Active member
Hello! I'm looking at adding at least one but maybe up to four cheek weld pads. One guy here(Terry Lightle) recommended Beartooth Comb Raising Kits. But I am in my early stages of research and thought I'd ask the rest of you guys. First of all, these are all hunting rifles so I'm not looking to add a lot of weight. I'm looking to shoot a little better and add a little looks and any other advantage it can give me. But I have seriously have only owned one gun in my life with one and I never hunted with it. Which one would you recommend and why. Thank you.
 
I ordered two of the Beartooths and two of the Triad Tactical Stock Packs! Just for anyone's information, the Beartooths, were only 21.99 at Cabela's. I ordered a set of grips for my new Beretta and put it over 50 bucks so express shipping was free also. Thanks for the info everyone! Merry Christmas!
 
I put matthews check risers on my tikka's. It's just a carbon fiber riser that you drill a couple holes in your stock and then set the level you need. Takes about 10 minutes to install. Google Matthews Fabrication. They also have a facebook page. I really like them. If my grandson's shoot the rifles it only takes a coupl allen wrenches to readjust for them.
 
I use one of those from XLR industries and put knobs on it to lower it to clean the barrel.
uT9GMx.jpg



For most of my rifles I use padded butt bags. I have high cheek bones and have a hard time getting a good cheek weld even then. I cut pieces of neoprene waders to put under the but bags to raise them even further.
7P9Qpu.jpg
 
Last edited:
Back
Top