does anyone know the weight of this arrow?

Originally Posted By: Tim NeitzkeI could not find any specs.

The best way is put them on a grain scale and find out.

x2 I tryed to find some specs for you man but I couldnt find anything. There should be a GPI size on the arrow shaft somwhere multiply that times whatever your arrow is cut to, add your nock, vein, and tip weight. Your best bet is to get it on a scale though. Chances are your arrows are going to vary alittle bit between 5 grains or so, but it will give you a rough weight of your arrows.
 
Somebody asked this question on the Archery Talk forum:

"wolverine arrows
does anyone out there know the specs of the junk arrows from wallmart?"


and got this answer:


"I just got off the phone with CX customer service; the specs weren't in any of their product guides (but Norma was very helpful and tracked down the specs from engineering) -- per CX: Wolverine Hunter 5060 are 9.9gpi and 6070 are 10.5gpi."
 
Originally Posted By: fw707Somebody asked this question on the Archery Talk forum:

"wolverine arrows
does anyone out there know the specs of the junk arrows from wallmart?"


and got this answer:


"I just got off the phone with CX customer service; the specs weren't in any of their product guides (but Norma was very helpful and tracked down the specs from engineering) -- per CX: Wolverine Hunter 5060 are 9.9gpi and 6070 are 10.5gpi."

holy cow i asked that, haha i couldnt find my post on it. that place moves fast with all thier members! thanks buddy!

Lonnie
 
my arrow is 297 grains and with my bh its at 422 grains all together!

not adding vanes or tip and nock! what do they average weigh?

im only shooting about 50lbs on a 257fps bow, is this arrow weight too much? should i get a smaller broadhead?
 
Well, I haven't been involved much in archery for the past 6 years or so, but back when I was the general rule of thumb was a minimum of 5 grains of arrow weight for each pound of draw weight, if I remember correctly.
 
i took off my 125 gr head and put a 100 gr head on, boy was i seeing more results, i was hitting everything! i just hope my 100 gr head is enough to enter into the deers vitals!
 
Im not an expert but your arrow total weight could be 250 and you be ok. If you dropped to 100g bh you be fine, you could even go with a 75g bh and pick up some speed. I have a buddy that shoot 75g BH out of a 70# bow. Hes killed Elk,deer, and Antelope with them. So a 100g for deer is plenty, as long as you shoot straight. JMO
 
Back
Top