Getting closer

[204farr]

Getting closer to getting the new one up and going.
The shop is messy but can clean up once she's finished up

 

[204farr]

Tool changer after the little
It time for the little lathe

 

[204farr]

To night project
Muzzel brake blanks
To run in the new little mill

 

[204farr]

So true!
Sweet!
Zombie green cerakote wrench
One way needed bearing one for clockwise and one for AnTI clockwise of TTS tool holder not bad at all for a home made mill

 

[Widow maker 223]

Very cool, looks like the mill works great. Were you milling a slot in the bottom of that vise?? I have made similar wrenches on the waterjet.

 

[204farr]

Yes putting pin in vise for fixture plate

 

[RSG223]

Nice shop pal! but it needs a clean up

 

[cropdamage]

Looking good Cody !

Need to brush up on my "Cody code" a little....grin

 

[204farr]

Ye same ol code speek the language

 

[204farr]

Tack knob any one

 

[204farr]

Setting part zerro for muzzel brake

 

[204farr]

 

[204farr]

A few brakes done
Sweet!

 

[Widow maker 223]

Very nice!!!

 

[204farr]

Barrel fluting macro done
Any number of flute cutom a twist and length all following out side counter with rotational scailing

 

[204farr]