L longrange454 Member Nov 30, 2017 #1 Any body have a diagram as to where to drill and tape your lower for a tension screw? Palmetto State told me their lowers with the PA prefix were drilled and tapped. Not true.
Any body have a diagram as to where to drill and tape your lower for a tension screw? Palmetto State told me their lowers with the PA prefix were drilled and tapped. Not true.
L longrange454 Member Dec 1, 2017 #3 I wanted an idea of how far forward from the rear of the receiver inlet. Last edited: Dec 1, 2017
4 44spl New member Dec 1, 2017 #4 I don't have a number for you but mine is center line of the rear takedown pin hole and right behind the grip screw hole. Hope this helps.
I don't have a number for you but mine is center line of the rear takedown pin hole and right behind the grip screw hole. Hope this helps.
Widow maker 223 Active member Dec 1, 2017 #5 Yup pull some measurements. Dead in the middle of the rear take down pin. I would use a set screw with a brass tip.
Yup pull some measurements. Dead in the middle of the rear take down pin. I would use a set screw with a brass tip.
L longrange454 Member Dec 2, 2017 #6 Thanks for the replies.I was thinking the center of the rear take down, but wanted to make sure.