MX160 / PVS14 behind Aimpoint

[the impactzone]

It works very well with a torch-pro 125 yard neck shot, was calling coyotes when the sounder of hogs came by, made a quick stalk upwind to 100 yards and lit a big boar up, the sow got confused with all the squealing and stopped just inside the woods I put another stalk and got her and another big 200+ boar that I don't mess with must have been rutting as several boars with this group of sows

 

[Pete Robinette]

I recently purchased a Eotech EXPS 3-0 two weeks ago and placed it ahead of my MX-160 with 3x magnification lens. I did not like it. I know several people do.
Have you tried the Eotech setup? It was great for light weight and easy of use but just did not feel confident with it. What Aimpoint model are you using or tell me what are the parts and pieces of that setup you are using if ya would. What are you using as a mount for the Mx-160/PVS14?
Thanks

 

[the impactzone]

the mount is a SNVG DLOC-PVS Go's on front behind focus ring of a PVS14, a tad lose on the MX160 but nothing a little friction tape didn't cure and only taped the tops 1/2 to push it more in line with the Aimpoint patrol rifle optic .

have seen them on Eotech and didn't care for them, with this set up it so close its almost the same as the aimpoint its self, do need the Torch-Pro had used another mount that did not allow it to get as close and was not happy.

High Tech Redneck has a new mount out that would be a lot faster to mount dismount but it looks like it lines up better high wise with the Eotech than it would an aimpoint?



I could get it closer if I took the J-Arm off for the helmet and removed the rear lens cap from the Aimpoint