Throw lever for Nikon 223 scope?

[case-nh]

My Nikon 223 scope's power adjustment is fairly stout. Any one have a throw lever on their's? If so what kind. Thanks.

 

[dway]

Check out this thread. They are DIY throw levers and a lot cheaper than the aluminum ones you can buy. If you want aluminum, check out the MGM Switchview. I just ordered one yesterday for my Leupold.

http://www.m4carbine.net/showthread.php?...-check-this-out

 

[Ky Col]

Thanks for the link.

I just ordered a P-223 scope and if it's too stout then I'll order me a set of those.

 

[the noobie]

I am curious how well those would work on the selector of the Nikon scopes. I am assuming the selector ring on the .223 line is similar to my Monarch. A little jimped edge then it smoothly tapers downwards. Only one raised portion. Hard to explain
Not sure how well those little straps would stay in place without wanting to slip off.

 

[Ky Col]

Did you ever get one for your P-223 scope?

If so does it stay on and does it work?

 

[jrnm]

the ones for the fishing rod work just fine.

 

[roky0702]

Just ordered some of the Breakaway coasters for my Tac30 1-4x. Should work well.

 

[CS TACTICAL]

I take it your putting it on an AR so here are two good mounts we recommend. ADM mounts are very good and the Burris AR-PEPR mounts work great.

Mike @ CSTACTICAL

 

[Ky Col]

What size do I need to order for the Nikon P-223 scope?