Oneleaf mt1000lrf 100 yds comparison

I did read a post somewhere that they did a firmware update to fix a shift of reticle issue [number 10 ] I think. My fit for the 50mm lens wasn't that tight with the original O ring and I replaced it with the supplied bigger O ring which made it significantly tighter but I can't say if I had a shift as I have only been using it as a hand held lately
 
DoubleUp said:
Vic, I'm running the latest firmware. I just thought folks might want to test it before trusting it.
Click to expand...
I am having a vertical shift issue as well as a tracking issue when adjusting zero, and after a few trouble shooting emails including a pic/video with Larry they are sending me 3 different sized O-rings to tighten up the lens attachment joint and their new thicker QD mount to replace the original I purchased.
Though I don't like the fact that I had a POI shift and found the shift issue, I can't say enough good about the customer service I have received from "Larry" over this and other times I contacted him to explain stuff about the scope that I could not get through my thick skull.
Also, this new mount is not listed on their website yet and they also have a version 11 update that as of 2 weeks ago was also not on the site. Larry sent me the v11 when we first started the trouble shooting.
 
The three scopes I bought have lenses that are really tight fitting.
I applied a very light coat of dielectric grease on the o-rings to make it much easier to change lenses.
No issues with a wandering zero with lens removal.
SJC
 
Back
Top