I know!!!....I seriously have a problem...lol But I just love toys, so thought I'd post some of my crap!.... This is my 2015 1000 cc razor. Stock, with a billet clutch assembly.
This is my kids 2013 900cc razor. has a .50 cal racing molly cage, billet clutch assembly, LED's and a few other things...
This is my 2013 4 seat 900cc razor, billet clutch assembly, running 30" mongrels. has a fresh Croyer top end and stock bottom end. gets the job done!
My buddies 2009 800cc razor-s with a Croyer big bore kit and running a 66mm turbo, dyno'd at 158HP. lots of little goodies!!!, thought I'd give him some props!!!
My wives 2009 bone stock Ranger, 700 other than a programmer, 14" Method bead-locks......normally this is used to get to the back country where a full size vehicle can't get too. Has an after market full molly cage, running the old HID's.
This is my "baby"...Built this with my buddy "Z", 2010 Tatum long travel sand rail, running an LS9 stroker with twin 88mm turbos. runs about 1650 hp at about 28 lbs of boost. Great for the dunes!!! Unfortunately runs on 120 octane and at $18 per gallon and gets about 4 mpg, doesn't gets out much...lol...which is a big part of off-roading out here.
4 seat VW sand rail, running a 2275cc stroker, Bus built Trans, 205hp, with twin 48 Weber carbs. 934 cv"s & Molly axles and wheelies with very little effort. Only weighs 1237lbs with out driver. frame is a Morton's chrome molly.
Stock 800cc 2009 razor-s. Yoshimura full exhaust .50 cal racing molly cage, pro-armor seats & doors.....
My "bad boy" crawler, I have used this to hunt before, but mostly just gets trailored to the desert. has a LS1, 4-link rear, 3 link front, 5" Molly heims, running an ARB locker front and rear, 36 spline Molly axles, 588 Gears, 14 bolt rear, dana 60 front. Atlas transfer case. 5 point Crow harnesses, front has 32" of travel & rear is measured at 46" of travel, 44" Pitbull tires mounted on Rocker bead locks. and a few other things??...lol
My 83' CJ7, has a 6" lift by Pirate 4X4 in Utah.
And this is my "hunt rig"! 2003 Chev Avalanche, gets me where I need to go, 6" lift, Tera-flex front long arm kit, LQ-80 Trans, triple front shocks, rear piggy Fox shocks, front Dura-blue CV axle assembly, dual battery set-up & seen a many dead coyotes in the back!!!
My 2012 900cc Razor, has a .50 cal. racing molly cage, billet clutch assembly, Croyer top-end, SSV Works stereo, with 6 speakers, billet hubs, Titan axles and cv's, and more crap!!
I'm sure many of you have serious issues with buying and building guns, as do I, but I just love toys!!!...my wife thinks I'm pretty much nuts having this stuff, but I have to say, this is "my vice" and I consider myself lucky that she puts up with me and my crap!! Hope some of ya'll post some of your rigs.....thank you...